How to clean a Brita water filter pitcher. Brita pitchers make it simple to have fresh, crisp, and clean water available. Because these pitchers are filtered at the source, they must go through a lot to generate the purified water that everyone desires while using them.
Sour flavors and pollutants can develop over time, affecting the taste of what you’re consuming. Don’t panic if this is also occurring to your pitcher.
The Brita water pitcher replacement filter eliminates all of these issues by removing any foul taste or odor and the majority of impurities that may still be present!
Returning to daily enjoyment of wonderful water will benefit you and everyone who drinks it!
How To Clean A Brita Water Filter Pitcher
We will discuss here the steps of Cleaning the Brita water filter pitcher.
Step 1: Disassemble
Before you can wash anything, remove the lid of the pitcher. Afterward, please remove the filter and set it aside without dirtying it.
Next, if a new filter is needed, trash the dirty one and get a new one. You shouldn’t need to clean the filter between uses as a good food disposal system will keep them sanitary. You are removing the reservoir from the pitcher complete disassembly.
Step 2: Clean the Lid
To begin cleaning your fountain, you’ll want to start with the lid. Make sure to use a non-abrasive, lint-free cloth for your electronic components wherever applicable; for certain products it can be safe to put them in water but do so at your own risk.
Finally, if any of the external plastic parts cannot be in direct contact with water, wipe them down with a damp rag or sponge and then be sure to dry off all of that moisture entirely.
Step 3: Clean the Pitcher
You’ll have to replace your pitcher now. It’s not enough to only clean the insides; make sure you also clean the outside!
To do so, use a non-abrasive roll-up or flat washing cloth, as well as some soft soap or dishwashing detergent. Ensure that all interior pockets have been cleaned and any dirt or residue removed.
Don’t forget to scrape the bottom corners, too. Then, with a clean towel draped over the top, ensure no soap is left on anything before separating each component from one other.
Step 4: Reassemble the Pitcher
Gather the pieces back together and follow the pitcher’s instructions to discard any water pitchers containing carbon dust.
Once you’ve thrown away clumps of carbon dust, please fill-up the pitcher with more water until it reaches a total of about three gallons for perlite.
See if any lumps or residue are clinging onto the sides of your bucket as well – make sure you get rid of them!
FAQs
Can you clean a Brita pitcher with vinegar?
To ensure your glass container is spotless, mix one teaspoon of white vinegar and one cup of water, saturate the sponge with the mixture, and clean the container.
Then rinsed and dried thoroughly; don’t forget to let all pieces air dry adequately to prevent mold from growing or other issues from arising.
How long do Brita filters last?
The Brita Regular Filter (white) should be replaced every two months. This is roughly after 40 gallons of water have been filtered through it.
The Brita Longlisting Filter (blue) needs to be replaced every six months, approximately after filtering 120 gallons through it.
Conclusion
Cleaning your Brita water filter pitcher is simple and should be done regularly. Filter the pitcher and clean it promptly after changing the filter is a good rule of thumb. A sponge or rag, which you should already have in your sink, will be your major tool for this process.
There should also be some dish soap in there — but only if you’ve recently eaten. In any event, this is an excellent approach to ensure that your equipment is fully working for as long as you own it.
Related Guides
