Whirlpool refrigerator water inlet valve. A dual inlet valve located inside the unit’s door may come standard on a Whirlpool refrigerator with an ice maker and water dispenser.
Because it connects to a standard water pipe, the connection is identical to what you’d find on a sink at home. You can pick between fresh water and ice by turning the door lever from cold to hot.
If your refrigerator stops creating ice or shows indications of leaking, it’s possible that it has to be repaired. This entails removing the interior of your refrigerator and tinkering with the tubing.
Due to the difficulties of working on such items, you should hire a specialist specializing in such repairs.
Whirlpool Refrigerator Water Inlet Valve
We will discuss here how to replace a whirlpool refrigerator’s water valve.
1. Unplug The Supply Line
Before moving your Whirlpool refrigerator far enough away from a wall to be able to unplug the appliance and access the water supply line below.
Make sure you first turn off both faucets of any kind on either side of the refrigerator’s water line.
Some water might leak out after unscrewing the appliance’s supply line.
2. Remove The Pannel
Remove the panel to reveal the hard disc mounted on a bracket. Four hex screws with 1/4-inch hexagonal heads can be used to secure the hard disc to the shelf.
Turn the nut driver counterclockwise in each slot until all screws are removed. This requires someone to help you hold things steady and secure behind the grips that keep the access panel or smaller cover in place while you can and re-install your screws.
3. Remove the two hex-head screws
Remove the two hex-head screws, and the valve will fall into your hands. Remove the old valve from the refrigerator to gain access to the wiring harnesses.
Remove the wires from the original valve and save them aside for later use. Turn the connections counterclockwise with your fingers to disconnect one set of lines from their previous point of contact and place them aside, along with the original valves they were joined to.
Because of the ice buildup on the ropes will most likely break off during this process, but that’s fine because they can be melted or cut away afterward.
4. Connect The Wires With Vacuum-Sealed Bags
Connect the wires from the vacuum-sealed bags to the replacement refrigerator water and ice valve’s proper terminals.
Match the screw holes in the replacement valve bracket to the screw holes in the body of your refrigerator.
Use the hex-head screws you removed from your old refrigerator valve to secure your new one.
Replace the hex-head screws on your refrigerator’s chef’s kitchen access panel. Please turn on the water shutoff valve on your refrigerator to activate its new water line.
Then connect it to yours with hose clamp pliers. If necessary, reposition your refrigerator using both leveling legs.
Then, click the Whirlpool appliance power wire to an electrical outlet using a grounded power strip surge protector with at least 800 watts.
FAQs
Why isn’t the water in my Whirlpool refrigerator coming out?
Ensure the water supply is connected to a cold water source with no kinks and that the shutoff valve to the unit is fully open.
Reconnect any abnormalities and straighten lines to restore sufficient pressure; check to ensure that all pipe and fixture joints are tight and secure.
Why did the water in my refrigerator stop working?
Every six months or so, you should replace your water filter. If you don’t remember how long it’s been since your last replacement, the chances are that it might be time for a new one. These filters can get clogged over time, leading to decreased water flow.
Conclusion
We hope you enjoyed our article about dual inlet valve repairs. With this knowledge, we know that you can make the most of your refrigerator and connect it to your home’s water supply.
Thank you for reading; we are always excited when one of our posts can provide useful information on a topic like this!
Related Guides
